Image: The construction Of Fluorine-Lithium compared to Hydrogen-Carbon gas in an electric current. Notice how one fits into the other....
Take note of the sex-principle.This causes every element of matter to be created in pairs. Also take note of Helium as cathode. Helium as an inert gas represents the static cold of space which will compress (or resist) into maximum heat and power conditions at the anode. Nature's first principle of power production and the construction of matter is to produce heat from the cold of space. Cold is the generator of energy not heat as mistakenly stated by scientists. Heat multiplication means to generate. Nature builds up heat in 4 steps. Every wave is a step-up transformer with four steps in an octave above its predecessor. Its RATIO is 0-8-64-512-4096. It is this octave step up multiplication which creates DENSITY and raises MELTING points. It is this principle of growth which will multiply gases of minus zero melting points into solids with melting points of over 3000°. For example: Helium has a sub-zero melting point, Lithium is a soft low density low melting point element, Beryllium is much more dense with a higher meltinh point the next is Boron and carbon with a melting point over 3600°. Science has never wondered how this high melting point is reached in 4 steps.
Always keep in Mind that LIGHT is the ONE thing in the Universe and you will understand the OPTICAL nature of matter. Also take note of the fact that in the electric current the dynamic equators (loops of force or anodes) and the static equators (cathodes) are parallel to each other. (In nature there is a phase shift of 90 degrees between the cathode and anodes - see below)
The aim of the electric current is to generate heat by impersonating light-waves. Light waves are like cyclones. Each wave can be compared to a dynamo which creates DC current. To emulate Nature's process the dynamo should generate much heat and become a reactor, connected with a steam turbine. The greater the heat, the more power lines can be connected to it. Heat needs to be generated in the armature of the dynamo which is made out of coils.
In coil design, the amount of wire determined for the coils, is fixed by the amount of heat of power one wishes to obtain. To add more wire means to add more power. Every turn of copper in a coil impersonates a twister in a cyclone in the creation of centrifugal vortices. Twisting is one way continuous spiral from its wide top to its apex with no reversal of windings. Therefor coils should not include reversal of windings.
In Nature, tornados reach their devastating force by means of contraction of their spirals. (the 4 steps in the animation represent the several conditions from no danger to danger as a result of contracting cones):